|
Conclusion Hopefully
this web site has provided you with the information needed to select or build a turbo charger
system for your vehicle. The information
provided should enable you to put together a safe, reliable system that
maximizes horsepower and torque without over-stressing the engine. If you are
planning on building your own system, select the highest quality components
that you can afford. Low quality or
knock-off type components will more than likely cause problems down the
road. It is better to spend a bit more
now than to have a cheap component cause a catastrophic failure later. On a final
note, never run an engine under boost without a proper fuel pump, injectors and
a safe tune or you will end up doing something like this!
Pulling an LS1 out
of the top of a Z28 after a boost related incident. The Z28 was not properly tuned for boost. |
| << Gauges for Turbo Charging - Previous Page |
|
All content on the Turbo Kits web site is copyrighted ©2009 |